News:

:) If you can't see some "in-line" images in a post, try "refreshing" your browser!

Main Menu

CAMECA Penning gauge cable

Started by Ben Buse, Today at 05:37:02 AM

Previous topic - Next topic

Ben Buse

Hi All,

Anyone have a spare CAMECA Penning gauge cable for connecting Agilent R0310301 penning gauge to Varian Multi-gauge controller,. OR know where one can be purchased for a reasonable price. Seems to be penning gauge is SHV and Varian controller is R232, but also that there are connectors between the two,


sem-geologist

?!? Which SX model is it? Penning Gauge on SX100 I know was Alcatel. The mentioned R0310301 is Inverted Magnetron Gauge (different technology from Penning). As it is standard part, Agilent sells standard cables (Still should, as They still sell same model IMG, and they took over Varian).
I.e: R03113010.

BTW what exactly do you mean by "R232"? I guess you mixed up protocole (RS232) which commonly use D-sub 9 pin? D-sub 9 pin is used for ConvecTorr Agilent low vacuum gauges as these do not require high voltage but is just higher current devices. There is no way D-sub would be used for 4kV connection, I believe you had to mix-up which cable connects to which card of Agilent/Varian Gauge Controller. IMG should be connected with High voltage coaxial cable connectors from both sides of cable ( I am not sure it is SHV-SHV  Varian/Agilent loves custom connectors).

I realy advice against buying used high voltage cables from uncertain sources (i.e. e-bay) as they could be worn out (i.e. used in humid environment and dialectric material partly broken by HV leakage), also clueless random folks tend to pack cables wrongly (these cables have minimal radius for bending - bend more and you damage dialectric - apply High Voltage and a leak is guarrantied). I completely understand that original Agilent cables cost an arm and a leg - but that is high voltage cable - not some USB phone charger cable.

What about spare cable? Why anyone would have it, unless it is spare and leaky (broken, but forgoten that it is broken). If it is only for test purpoises (to test IMG) - again it could result in False False indentification of problem (IMG would not strike because of leak in the cable - this would result in assumtion that IMG is broken, while it would be actually a cable which is broken).


Here I found this on Ideal vacuum:
https://www.idealvac.com/en-us/Varian-Agilent-XGS-600-Multi-Gauge-SenTorr-Gauge-Controller-to-IMG-100-Sensor-CABLE-10-ft/pp/P104125

however standard 3m/or 10 feet Agilent/Varina cable could be too short. If you can confirm that it is SHV - SHV cable - then there are few (budget friendly and safe) options for custom built depending from IF your gauge is bakable, or not (Is it SXFiveFE or SXFive or SX100?). If it is not bakable then standard SHV could work (does not need expensive PEEK isolator in connector).
I.e. there is this www.koax24.de where you could order custom lenght SHV-SHV assembled cable.



If it is bakable, then I would try asking at https://www.hivolt.de/   ... but I guess You will find then Agilent official custom cables less expensive.